The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours

Clutch friction plate for the single plate clutch fitted to 2007 on 4 valve models

Also known as Guzzi ref. 976053

 This part is available by special order, request a quote

B064100

Lambda sensor with 660mm lead

 This part is available by special order, request a quote

 896110 MG896110

TPS for throttle body on 2 valve/cylinder models

 Order now and we will post your order within 7 days.

 05112830 GU05112830 05 11 28 30
 0511 2830 0511.2830 05.11.28.30

Pair of black medium rise handlebars from Domino

Handlebars have not been drilled for switchgear locating tabs. Designed for Griso 1200 but may suit other bikes with handlebar risers. These handlebars can be fitted to the Griso 1100, some customers report that they are an improvement over the Griso 1100 handlebars as they are narrower and pull back more. Superceded by Guzzi ref. 886111

 This part is available by special order, request a quote

978204-z 978204 MG978204

Rear speedo sensor for ABS models

There are several variants of these sensors, please compare to the sensor on your bike or contact us with a chassis number before ordering

 This part is available by special order, request a quote

 05683730 GU05683730 05 68 37 30
 0568 3730 0568.3730 05.68.37.30

Pair of black ABS handguards with fitting hardware, these protect clutch and brake levers from damage as well as providing some weather protection for your hands. Supplied as a pair with bar end weights, bar end plugs (only for Stelvio), fitting information, spacers, bolts and washers.

Guzzi part ref. 883253 + 883254

 This part is available by special order, request a quote

 983157 MG983157

Fuel assembly including quick release connector

 This part is available by special order, request a quote

 977149 MG977149

Timing sensor for ignition and tacho

3 pin block connector. Used on models with the smaller 15M ECU

 2 in stock

 01721600 GU01721600 01 72 16 00
 0172 1600 0172.1600 01.72.16.00

Lambda sensor. Wiring harness may be shorter that your existing connector on some modeels, and will therefore need extending.

 This part is available by special order, request a quote

 32727010 GU32727010 32 72 70 10
 3272 7010 3272.7010 32.72.70.10